1. Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.
    Dismiss Notice

Keitai's Recent Activity

  1. Keitai attached a file to the thread Euro hinges.

    [ATTACH] Put it in. I screwed straight into wall for plates believed there was wood in there but bottom two came out so put in plugs....

    20211020_144504.jpg 20211020_144450.jpg 20211020_144442.jpg 20211020_144511.jpg 21 Oct 2021 at 7:08 AM
  2. Keitai replied to the thread Best bit for multi tool for skirting and stuck chuck.

    Dont think there's a depth stop. Dewalt. Just on/off and lock I think

    20 Oct 2021 at 8:20 AM
  3. Keitai replied to the thread Best bit for multi tool for skirting and stuck chuck.

    3 in 1 sprayed into it?

    19 Oct 2021 at 9:07 PM
  4. Keitai attached a file to the thread Euro hinges.

    [ATTACH] Ok so just practiced on my kitchen door lining- i place it on the floor and marked across from centre of hinge then marked 7mm...

    20211019_185101.jpg 20211019_185049.jpg 20211019_173402.jpg 20211019_190109.jpg 19 Oct 2021 at 6:58 PM
  5. Keitai replied to the thread Euro hinges.

    Yeah I think so. Arent all euro hinges like this? The joiner who knocked up the door recommended them. In fact sold me them. Won't...

    19 Oct 2021 at 4:58 PM
  6. Keitai posted a new thread.

    Best bit for multi tool for skirting and stuck chuck

    Is this the right bit to cut a bit if skirting (in situ) in multi tool? [ATTACH] [ATTACH] and the chuck in my drill is stuck, how I get...

    20211019_095837.jpg 20211019_095831.jpg

    Forum: Tools and Materials

    19 Oct 2021 at 10:00 AM
  7. Keitai attached a file to the thread Euro hinges.

    I got three hinges so pump it into position then mark the centre line across from centre of hole to lining? Then put plate in from...

    20211019_094454.jpg 20211019_092014.jpg 20211019_091659.jpg 19 Oct 2021 at 9:53 AM
  8. Keitai posted a new thread.

    Euro hinges

    Got some recessed Euro hinges. Before I screw them into door, want to get them at 90 degrees to door edge. Shall I use straight edge...

    20211019_001319.jpg 20211019_001242.jpg 20211018_231525.jpg

    Forum: Wood / Woodwork / Carpentry

    19 Oct 2021 at 12:23 AM
  9. Keitai attached a file to the thread Cherrypicker.

    These are the two levels we try to get right (with wheels off ground). The outriggers not going onto a manhole or drain etc either and...

    Screenshot_20211017-072804_Gallery.jpg 17 Oct 2021