Hi all, my 831 has been a little temperamental the last couple of days after a pcb board change. I've read the fault codes and cleared them and the same code comes back, F53. Am I right in thinking this to do with the gas valve? Are these valves repairable by a gas fitter or is it just a swap...
Hi all, had a control board go down on my vaillant ecotec plus 831. I fitted a new board today and the boiler came back to life. I was just wondering if I would have to change any settings in the service menu at all due to the new board. Thanks in advance
Jim.
Hi all, had a call from the wife saying the boiler had switched off (no display/heat or hot water). When I arrived home I checked the usual rcd and boiler fuse and all was OK. The boiler is getting mains feed and I was led to believe that the pcb should have 2 onboard fuses. I found the one near...
Hi all, I've discovered some loose bricks above my front door. It looks like it's been caused by a bad install of the front door, also the frame of the door is now moving along the top. It looks like the canopy will have to be removed as two coarse are loose. Can someone tell me what is needed...
Hi all, I've just had my bathroom boarded and skimmed. I'm wanting to fit some pvc cladding and was wondering if I should pva the plaster first before glueing?
Many thanks.
Hi all, need a little advice please. Just replaced a diverter valve on a conventional boiler system. Drained system down to enable change of valve, fitted valve and bleed every radiator. Problem I'm having is that the upstairs radiators are getting hot but downstairs are cold. Any ideas please...
Thanks for the replies. The boiler is a "vaillant" eco 831. The pipe work is 15mm. I've just checked the flow rate of the hot water and fully open is about 10lpm, it gets very hot when the flow is reduced to about 3.5 - 4 lpm. This was using the onboard diagnostics
Hi all, looking for a bit of advice please. I have a valiant combo boiler and the trouble I'm having is the bath hot tap runs only luke warm unless I turn the flow right down. Would anyone have any suggestions please?
Many thanks
Jim.
Hi all, I have purchased some self adhesive vinyl planks and was wondering what is the best stuff to cover the floor boards with please??
Many thanks
Jim