Recent content by snr652

The Boiler case is hot to touch, the selector switch is set at 0 which should be the off position, therefore only the pilot light is lit, however, the temperature guage is reading 60 degrees. Is this a PCB fault? How can the boiler still be hot when it is not switched on?

The Boiler case is hot to touch, the selector switch is set at 0 which should be the off position, therefore only the pilot light is lit, however, the temperature guage is reading 60 degrees. Is this a PCB fault?

Hello, I think my Vokera Excell 80 is possibly overheating, can anyone point me to the problem area/ areas?

The area is about 100ft sq and I have a couple of areas of quite thick clover about 1ft sq. I have tried pulling it out trying to get back to the roots but it keeps coming back, hence the cry for help.

THE WHOLE DIVERTER VALVE WAS STRIPPED DOWN, CLEANED & ALL NEW 'O' RINGS, DIAPHRAGMS AND NYLON BUSHES, ETC REPLACED WITH A GENUINE VOKERA REPLACEMENT KIT. THE VALVE APPEARS TO BE OPERATING SMOOTHLY WHEN I CALL FOR HOT WATER.

Can anyone give me a good way to get rid of clover in my lawn?

I had the boiler serviced in September by a Corgi registered engineer, the same engineer also fitted me a new Diapragm in the diverter valve in November. Any ideas

MY COMBI STOPS FIRING EVEN WITH THE PILOT LIGHT STILL LIT & THE PRESSURE AT APPROX 1.1 Bar. THE HEATING GOES OFF, AND IT WON'T FIRE UP WHEN DOMESTIC HOT WATER IS CALLED FOR, THE BOILER CAN BE HEARD CLICKING BUT DOES NOT FIRE. THIS HAS HAPPENED 3 TIMES IN THE LAST WEEK, LASTING ABOUT 2 DAYS...