1. isolate the water supply to the float valve (or if there isn't one fitted, close the main stop cock)
2. empty the cistern by flushing as best as you can, then finish it off with an aquavac (I use an old Vax)
3. Undo the two nuts under the cistern (if you have a low or high level cistern) and lift the siphon to unhook the handle
4. Clean the area around the hole in the bottom of the cistern
5. If your float valve looks like it's seen better days take this opportunity to replace it with either a brass part 2 or plastic part 3 float valve
6. Get a turbo siphon (internal overflow) and fit with new seals - DON'T use silicone a. it contravenes water byelaws and b. the rubber seal doesn't get compressed properly because it'll slide out under compression - don't forget to put flushpipe nut then seal on first, reconnect the handle loop, then tighten the backnut up enough so the siphon doesn't move
7. slide flushpipe seal into place (I've recently started putting a few wraps of ptfe around the joint because it's not easy to make these seal straight off) then tighten the seal nut
8. fit your new float valve - you'll need to adjust water level after
9. if there isn't a service valve, fit one as close to float valve as possible - this is required under water byelaws
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local