I have a worcester Bosch 26 32 oil combi boiler and have been operating it for some time just on a timer for CH (hot water is set to on demand).
I have now taken the plunge and bought a Honeywell cmt927 Rf Chromotherm wireless thermostat.
I have located the linkage wire that needs to be removed from the main circuit board for connection to the receiver however, I am not entirely sure the best way to provide a live feed.
I was thinking of using the existing live and neutral connectors that supply the timer; I would connect the receiver into these with the existing wires so that the connection is in parallel.
I am hoping that I do not need to run a spur from existing wiring to feed the receiver.
Any comments would be greatfully received.
Many thanks
I have now taken the plunge and bought a Honeywell cmt927 Rf Chromotherm wireless thermostat.
I have located the linkage wire that needs to be removed from the main circuit board for connection to the receiver however, I am not entirely sure the best way to provide a live feed.
I was thinking of using the existing live and neutral connectors that supply the timer; I would connect the receiver into these with the existing wires so that the connection is in parallel.
I am hoping that I do not need to run a spur from existing wiring to feed the receiver.
Any comments would be greatfully received.
Many thanks