remove zone

stayclean · 7 Feb 2015

hi all
i would like to remove the actual wire from a zone in my kitchen. ive traced wire back to control box which is a challenger alarm systems and located wire. i do no when you remove cover from control box it go into tamper mode. looking for advice on next stage on removing wire and ??????????????? do i need to put a loop in and how.
any help would be appreciated
thanks David

sparkymarka · 7 Feb 2015

Probably .... Challenger is a city electrical brand , so it could be one of many control panels , but at a guess a,700/800l panel so you would use a link to bypass the zone..

stayclean · 7 Feb 2015

Thanks for reply
is its possible if i take a photo of control panel with cover removed showing zone i would like to remove. can u tell me were links need to go in
thanks for all your help

sparkymarka · 7 Feb 2015

stayclean · 8 Feb 2015

ive attach a photo showing zone 4 were wires go, red and blue
Another ? i have alarm had not been used for several months i notice siren box outside has a small flashing red light going from side to side. could this possible a fault on siren box.
thanks for any help

alarm box

stayclean
8 Feb 2015
1

alarm box

stayclean
8 Feb 2015
1

sparkymarka · 8 Feb 2015

cut the red wire about 3 cm from the pcb , remove the blue wire , strip the end of the red wire still connected to the pcb , now put the stripped end into the terminal where the blue wire was removed .... You have now created a small shorting link in zone 4 ..... Job done .... No the lights are supposed to flash on the bellbox

stayclean · 8 Feb 2015

thanks again for all your help

Europlex · 8 Feb 2015

You two both colour blind? It's Orange and Blue, same as with the other circuits shown

sparkymarka · 8 Feb 2015

If they say it's red I ain't going to confuse them ! 😛

stayclean · 8 Feb 2015

hi again
got a faulty PIR Now need changing. Bought a Quest Wired PIR. When ive checked wiring installations its a different set up. trying to solve were wires go in new PIR. ive uploaded 2 photos showing old pir were wires are and new one which requires wire fitting
Any help would be appreciated

Wired PIR

stayclean
8 Feb 2015
1

NEW PIR

stayclean
8 Feb 2015
1

sparkymarka · 8 Feb 2015

Relay on quest is RED and blue either way round
Tamper on quest is black and yellow either way round
Ground on quest is what ever is in the - on the medusa ( can't see from photo)
+ on quest is what ever is in the + on the medusa

stayclean · 8 Feb 2015

Thanks for reply

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

remove zone

Similar threads