Making a light fitting
- Thread starter mattym
- Start date
Sponsored Links
It does, and I almost suggested it for that reason. However, there is no way of using it for the OP's application (even with linking pairs of terminal strips) which doesn't involve putting two conductors into at least one of the terminals.
Kind Regards, John
Yebbut terminals are rated for 1.5mm cables. 2 x 0.5mm flex shooulnd't be too difficult.
It certainly wouldn't worry me, but the OP appeared to be looking for (needing'?) a 'totally straightforward' approach!
What I would probably do if I were in the OP's position is probably best not said here
Kind Regards, John
Sponsored Links
I've got a 20a 4 way junction box and some 2 core flex so now I just need to wire it up I'm not too bothered about complexity I just want to make sure it's right and safe
Last edited:
well a 20A round JB is fine, but it's much bigger than you need it to be (physically) a 6A round JB is tiny in comparison and does exactly the same job
How are you going to stop the wires pulling out of this 20 amp junction box
Going to use some flex cord grips
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
