Honeywell Accenta G4 mini

There appears to be 2 connector blocks for the tamper circuits, and another pair with electrical tape round them; but is it a complete circuit end to end.

Assuming that it is, you're going to need to test each sensor in turn, by connecting them one at a time into the tamper curcuit on the board till you find the one at fault.
 
Sponsored Links
Ok I will try this tomorrow. The one in the tape at the right hand side is for 2. Outside bell boxes. There doesn't seem to be any problems with bell boxes. The fault must be on pir somewhere.
 
The bell boxes go into their own tamper circuit, but would still register a tamper fault, so link that one out and test.
 
Ok will test tomorrow night. When I linked out zones 1-7 alarm set but only door contacts triggered alarm. Would this be due to tamper wires or a different reason?
 
Sponsored Links
The door contacts shouldn't have triggered the alarm. If you've programmed the alarm, then zone 1 gets used for the door contacts, and you set a delay of 30 seconds to give you time to get to the panel and enter the code. Going back to your original post, you did a walk test, but did the panel sound as you went past each PIR.
 
Sorry I was not very clear, the door contacts would have triggered alarm had I not entered code before delay expired. I did walk test, only door contacts registered a 1 on LCD keypad and made sound. All pir as I walked past them did not make sound nor register a 1 on LCD keypad. Red light on each pir indicated it had sensed me.
 
Sorry LD, double checked the back posts, and you cleared the fault when you linked out the main tamper circuit, so it can't be the bell, but have you programed the system yet.
 
I have been trying to adjust program. Need to work my way through to see what I need to do. I think I marked all zones as used except zone 8, which is not, but is linked out.
System set as timed exit. When I set alarm and exit through door (zone 1). It sets. But none of pir trigger alarm when set so I think I need to adjust something in program.
 
Assuming you've got the door on zone 1, then zones 2-7 should get set as used immediate (unless you've got a PIR on the route through to the keypay which should be zone 2). Then try you're walk test again. The accentas a pretty good basic system, and quite simple to set up.
 
I am wiring each PIR into tamper 1 at a time. On the 2 I have tried so for on walk test I get this
IMG_0504.JPG

What have I done wrong.
I will post pictures of PIR wiring and door contact wiring
In following posts
 
You've got the tamper circuits and the alarm circuits the wrong way round.
 
Each time I wire a single zone PIR into tamper, on walk test 1 goes under T and not under zone number, except door contact zones
 
D

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
You must log in or register to reply here.
Sponsored Links

Similar threads

N
Accenta Mini Gen4 loop tamper
2
Replies
20
Views
9K
coldelsol
C
S
Accenta G4 tamper fault lockout
Replies
4
Views
1K
steq184
S
S
Accenta Gen 4 issues
Replies
10
Views
2K
Alarm
A
V
Accenta Mini G4 Tamper Lockout
2
Replies
18
Views
31K
sparkymarka
sparkymarka
S
Honeywell Accenta - fault when PIR is triggered
Replies
3
Views
1K
wired1up
W
Back
Top