wiring colours

Joined
19 May 2017
Messages
2
Reaction score
0
Country
United Kingdom
Hi

I am installing some new lights in my flat and and am unsure which mains wire is live and which is neutral.

The colours are black, yellow and green and the flat was built in the 70s. I am happy that green is earth but am unsure about live and neutral.

I can't just follow the wiring for the old lights as it turns out some were connected brown (light fitting) to black (mains) and blue (ligtht fitting) to yellow (mains), and others the opposite way around.

Help!
 
Sponsored Links
Hi

I am installing some new lights in my flat and and am unsure which mains wire is live and which is neutral.

The colours are black, yellow and green and the flat was built in the 70s. I am happy that green is earth but am unsure about live and neutral.

I can't just follow the wiring for the old lights as it turns out some were connected brown (light fitting) to black (mains) and blue (ligtht fitting) to yellow (mains), and others the opposite way around.

Help!
First of all welcome Lynne.
I think a guess can be made about his but more detail, especially good pictures of the various locations needed please.
 
Before disconnecting anything make sure you take pictures, noting where wires go to and even putting some identification on each cable (like numbers, letters, dots, masking tape, etc...). But yes if you can upload some pictures it would help us give you some safer advice.
 
Sponsored Links
To know for sure, you need one of these
TMDL6780.JPG

and one of these

or one of these
 
Multimeter is fine, just disconnect at the cu and measure from there.
Not sure how that comes regarding all conductors being identified at their terminations though, it should be either new, old, or sleeved colours.
 
Seems obvious to me.

A 70s block of flats.

Conduit.

Singles.

Red used as permanent live.
Black used as neutral.

Yellow used as switch live.

Only switch live and neutral required at light fitting (tho reds probably looped straight through ceiling pot box.

Easy way to confirm all of the above is to look behind a light switch, where I would expect to see yellow and red wires.
 
Seems obvious to me.

A 70s block of flats.

Conduit.

Singles.

Red used as permanent live.
Black used as neutral.

Yellow used as switch live.

Only switch live and neutral required at light fitting (tho reds probably looped straight through ceiling pot box.

Easy way to confirm all of the above is to look behind a light switch, where I would expect to see yellow and red wires.

ureavinalarf, a flat wired in conduit and singles perhaps if it was 40's or 50's, in the 70's it would have been piro/micc.
 
There is some council blocks in east London that have Pyro flushed in the walls, I think a it was a phase they went through in case someone nailed into the wall, though a majority I have seen have been loop in conduit.
It is a remote possibility its 3 black pyro cores marked with Green and Yellow phase tape I suppose.
 
in the 70's it would have been piro/micc.

I have seen more 70's flats with conduit that I have MICC. Octoflex or Aercon were used too.

As for the 40's and 50's, Octopus was often used, with a huge central JB for lighting.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top