Ceiling light - 3 wire loop - is it a problem?

Sponsored Links
Thanks for all of the input.

I still haven't found out who installed the new pendants, but I just received a new message from the tenant.

"The light pendants have been fitted and are working, it just seemed unusual to the fitter to install an 3 way loop unless you are intending to have more than one switch per light."

Does the way that it is wired have anything to do with having more than one switch, or is it further proof that the "fitter" didn't understand the wiring?
 
Nope, the fitter doesn't know what they're doing. Any UK trained electrician will know about 2 and 3 plate wiring.
 
From the picture you put up, it all looks exactly how you'd expect it to look. It's very standard.
So I'd say your tenant's "fitter" is not competent with electrics and therefore shouldn't have done it.
 
Sponsored Links
All very concerning for the OP the wiring is bog standard. :eek: and fine (ignoring the lack of a sleeve)
 
Don’t see what more than one switch has to do with it. The second and third switch don’t need to connect to the light fitting so that’s an entirely redundant arguement.

If you had spotlights and they were 3-plated then there could be an arguement that that was poor form but still wouldn’t be wrong
 
Thanks for all of the input.

I still haven't found out who installed the new pendants, but I just received a new message from the tenant.

"The light pendants have been fitted and are working, it just seemed unusual to the fitter to install an 3 way loop unless you are intending to have more than one switch per light."

Does the way that it is wired have anything to do with having more than one switch, or is it further proof that the "fitter" didn't understand the wiring?
That would make sense if instead of 3 way loop he said 3 core switch cable. But even if that, it would not apply here as it looks like 2 core switch cable.
 
You should ask your tenants, what do they think that centre 'loop' terminal on a ceiling rose is there for?

Why they think they had to e-mail you to tell you they don't approve of three-plate wiring, I do not know.
 
Nope, the fitter doesn't know what they're doing. Any UK trained electrician will know about 2 and 3 plate wiring.
whssign.gif
your tenant's "fitter" is not competent with electrics and therefore shouldn't have done it.
whssign.gif


And the tenants should not have been allowed to get him to do it.


Why they think they had to e-mail you to tell you they don't approve of three-plate wiring, I do not know.
I do.

It is because they are idiots.
 
Old Kettle,
I take it you have asked for the testing documentation for the electrical works for your duty of care and insurance.
I certainly insist if they make any alterations, and if they fail to I get it checked and they pay the bill. One of my tenants did several changes and out of their 6 weeks deposit they only got £30 returned, they took me to small claims court and I when produced the invoices (both sets, from the contractors to me and from me to tenant) I realised I'd made a mistake with the amount owing, I'd not included the VAT and court said I should retrospectively claim for this too.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top