Unvented cylinder and balanced cold

Joined
18 Mar 2018
Messages
869
Reaction score
59
Country
United Kingdom
When installing an unvented cylinder do most tend to use balanced cold for all cold outlets including the kitchen sink tap? So take the cold mains straight to the cylinder and the back to all cold water outlets including the kitchen sink from the tee for balanced cold on the composite valve. Or is it standard to feed the kitchen tap straight off cold mains as this is were the cold main usually enters the building then go to the cylinder and take all over supplies off balanced cold? If the kitchen tap is dual flow this wont be a problem? Thanks for any input.
 
Sponsored Links
Ideally you’d want balanced cold at all outlets where you have mixers for hot and cold... this way the lever of any mixers should just be able to be left in the centre of its arc and just lifted up to provide the perfect mix of hot and cold at the right temp. If your kitchen sink has separate taps then it doesn’t need to be off the balanced cold. Outside taps are also better off direct from mains.
If installing a water softener then it’s also good practice to run non-softened water to each basin in the house.
 
The Kitchen tap is a mixer tap but it's dual flow so the water doesn't won't mix in the tap. So the cold can't potentially back fill up the hot.
 
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top