We have quite a large uPVC Bi-Fold door (2.4m x 1.9m) which was supposed to open outwards. The builder screwed up and ordered it inward opening.
At the time they were more expensive then now. So rather then jeopardise the rest of the job (he may well have tried to find a way to make up his loss) I came to an arrangement with him.
Now we're getting a larger dinging table it's causing a problem The cost of a new one will be ~£2k, so i'm wondering if it would be possible to reverse the entire frame.
This will mean the beading will be on the outside. And also the fittings will have to be switched around with the holes on the other side covered in some way. But wondering if its worth getting someone to take a look. Or if its a waste of everyones time.
Thanks
At the time they were more expensive then now. So rather then jeopardise the rest of the job (he may well have tried to find a way to make up his loss) I came to an arrangement with him.
Now we're getting a larger dinging table it's causing a problem The cost of a new one will be ~£2k, so i'm wondering if it would be possible to reverse the entire frame.
This will mean the beading will be on the outside. And also the fittings will have to be switched around with the holes on the other side covered in some way. But wondering if its worth getting someone to take a look. Or if its a waste of everyones time.
Thanks