Gjd help

dbaplaya · 21 Jul 2019

I've purchased an opal xl, 4 zone expanded and digi zone. Can anyone advise on the wiring from the 4 zone expanded to the opal detectors. Inside the 4zone it says zone 1 for gjd detectors. The connectors are A1 A2 A3 S1. How does the correspond to the wiring in the gjd detector which has - A S +

The manual is confusing. Any one had experience of these please?

sparkymarka · 21 Jul 2019

+ to + on expander
- to - on expander
S to S1....this is area1 ....so will tell the controller it’s dark
A to A1....this is area 1 ....so will activate the lights when above says it’s dark
So if you where going to have another opal head in zone 1 , you would repeat above ...but put it in A2 if you wanted to know which sensor had picked up movement ...

dbaplaya · 21 Jul 2019

Ok that helps a lot and makes it pretty simple. I'm going to have 4 opals on 4 different zones so I just repeat the above I take it. Also I have an extension speaker which I will put upstairs. Where would this wire in to? Thanks again.

sparkymarka · 21 Jul 2019

You can’t connect a speaker , extra keypad or piezo sounder wired to aux , you would need two for all 4 zones as each pair , 1+2 , 3+4 have separate aux

dbaplaya · 21 Jul 2019

Cant I connect one piezo to do all the zones? I'd like a buzzer to go near the outside of the house so people know they are being watched etc

dbaplaya · 21 Jul 2019

Ok all wired in now. One annoying thing is the beep, I used to have a Voltek system which had a pleasant chime. This seems to have an annoying beep which cuts off then goes again, if that makes sense. The voltek was a constant beep if say someone was walking across the drive and breaking the beam. Any way to change this on the GJD?

Handymanjo · 22 Jul 2019

You could use the voice recorder in place of the peep.
You can record a separate messages per zone.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Gjd help

Similar threads