Galaxy dimension

Hello guys
I have a strange problem with a GD264 panel.
So, when I try to set the system, a zone that is closed, change state and opens, and don't let me set the systems. I verified during the timed set if something open the zone, but nothing found.
The zone is a motion detection, defined as intruder. Before seting the group is ready, showing R. As soon as the timed set count down the zone opens without reason.
To set the system I have to omit the zone.
Any ideas?

Have you tried bypassing the zone with a 1K resistor to see if the problem persists? Can you move the sensor to a different zone to prove the sensor/wiring? Sounds like it might be a firmware issue.

Hello, thanks for the answer
Yesterday I finished late at night, I didn't try anything.
I will see that monday .
The firmware is 7.02. I think I can do a firmware upgrade if necesary.
Thanks a lot men.

Hello again
Another question about gd
Can I link a zone with an output, if the output is not alocated to a group?
For the moment I cannot tested by myself because I can't install galaxy RSS. (actualy when I start commserv the frontshell don't come up)
Thanks.