I'm fitting an outside light and I want to make sure that my wiring plan is okay
I plan to
1. Replace existing 1 gang switch (which controls an internal light) with a 2 gang switch so that it can controls both internal light and external PIR light
2. Feed 1mm cable from switch connecting brown wire to COM and Blue wire (with brown tape) to L1
3. Open up existing ceiling rose a use new piece of 1mm cable as follows. Brown wire to Loop and blue wire to neutral
4. Take the end of both cables (switch cable and ceiling rose cable) and connect the brown cables together with a wago connector
5. Connect Blue wire from ceiling rose to neutral in outside light
6. Connect Blue wire from switch to Live on outside light. Place brown tape on this
Is my wiring plan okay?
Is their a way to simplify my wiring?
I will connect the earth cable as i go along as well
I plan to
1. Replace existing 1 gang switch (which controls an internal light) with a 2 gang switch so that it can controls both internal light and external PIR light
2. Feed 1mm cable from switch connecting brown wire to COM and Blue wire (with brown tape) to L1
3. Open up existing ceiling rose a use new piece of 1mm cable as follows. Brown wire to Loop and blue wire to neutral
4. Take the end of both cables (switch cable and ceiling rose cable) and connect the brown cables together with a wago connector
5. Connect Blue wire from ceiling rose to neutral in outside light
6. Connect Blue wire from switch to Live on outside light. Place brown tape on this
Is my wiring plan okay?
Is their a way to simplify my wiring?
I will connect the earth cable as i go along as well