Texecom Odyssey X-BE Bellbox

Joined
11 Aug 2019
Messages
62
Reaction score
1
Country
United Kingdom
Hi All,

I'm upgrading my alarm system from a Scantronic 9448+ to a Texecom Veritas Excel. The Scantronic alarm hasn't worked properly since we moved in the property. The keypad had stopped working so this alarm system was replaced by a Yale Easyfit Wireless alarm. But I wanted to get back to a wired alarm system (more reliable).

My existing wiring is already there from my previous alarm system (all wiring to PIR's etc) but I read in the manual for the bellbox that it needs 8 core cable. I've only got 6 core installed for the previous alarm box. All alarm cables already exist but are all 6 core cables.

Will I need to run 8 core cable so I can install this new bellbox?

Regards,

Brett
 
Sponsored Links
6 core will be fine

ABCDS (12V, bell trigger, Tamper, 0V, Strobe) leaves a spare
 
Re-Read the manual for the bell box and read the part where it says * Not applicable to Odyssey X-E & X-BE which applies to the fault relay, Tamper relay and test on the bell box.

Goes to show, read instructions properly and thoroughly, LOL. Thanks again for your help secureiam.
 
Sponsored Links

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top