Veritas r8 re-siting panel

houstonwehaveaproblem · 6 Jul 2020

Hi

I need to re-site my control panel so need to remove power while doing so.

I guess the bell box will activate when I do this.

I have the engineers codes. Is there a way to ‘hold off’ the bell or similar while doing the panel move?

sparkymarka · 6 Jul 2020

Depends on bellbox ...but if not put the battery on the the bell supply

houstonwehaveaproblem · 7 Jul 2020

sparkymarka said:
Depends on bellbox ...but if not put the battery on the the bell supply

Thanks

it’s a Texecom Oddysey X3

secureiam · 7 Jul 2020

if the strobe is connected you can place the bell into hold off mode, cnt remember the exact instructions for doing so on the veritas but its strobe on off about 3 times i think and then the comfort leds will indicate its in hold of mode. On a premier in bell test just press omit and it takes care ofit but ages since I have done one on a veritas

houstonwehaveaproblem · 7 Jul 2020

Thanks

secureiam said:
if the strobe is connected you can place the bell into hold off mode, cnt remember the exact instructions for doing so on the veritas but its strobe on off about 3 times i think and then the comfort leds will indicate its in hold of mode. On a premier in bell test just press omit and it takes care ofit but ages since I have done one on a veritas

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Veritas r8 re-siting panel

houstonwehaveaproblem

sparkymarka

houstonwehaveaproblem

secureiam

houstonwehaveaproblem

DIYnot Local

Similar threads