Aluminium coupler for Solidoor

ASEJLSE · 11 Jul 2020

Hi, I have a Solidor door with 1 full length side panel. An aluminium 10mm thick coupler is supplied with plastic trims to cover the jonts. One side of the coupler is smooth/flat and the other has 2 small tongues on each side (sicking out about 2 mm and 4 mm from the edge). I’m not sure which way round the coupler should go, would the smooth side go on the inside or outside?

Many thanks for any advice.

ronniecabers · 12 Jul 2020

when you line it up.on the door frame, does ' tongue ' side fit proud ? From memory thats the outside as then the trim clips on and completely covers the joint

ASEJLSE · 13 Jul 2020

If I put the smooth side on the outside it fits proud (coupler 2 picture), however the tongues dont fit flash on the inside. Is that OK?

Ian H · 22 Jul 2020

Have a look at the pictures on here:

https://www.windowwidgets.co.uk/downloads/brochure/?brochurepage=4

Ian H · 22 Jul 2020

To me (I’m no expert) it looks like the coupler isn’t compatible with your plastic profile.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Aluminium coupler for Solidoor

ASEJLSE

Attachments

ronniecabers

ASEJLSE

Attachments

Ian H

Ian H

DIYnot Local

Similar threads