New plaster but damp issue which paint to use

Typically, back to back terraced housing would have had a main sewer running down any back entry or alley, midpoint between the backs.
Finding manholes and investigating will help you. Go to the nearest street or road and if possible work back from the street manhole.
 
Sponsored Links
I didn't get much joy with a post in the builders forum last night. Hopefully I'll get something back from this.

Today I stripped some of the paint and cleaned up the wall. I have limited time at the moment due to work so I go along when i can.
I also got the heat gun out to help dry some of those bricks. Tomorrow, I'm hoping to strip the plaster where the paint stops peeling. That's going to be a biggish job as I have to deal with the internal partition wall as well as the facing wall.

What i did notice however after cleaning the wall, at some point it looks like they had some damp proofing done, and I can also see a damp proof cause where the air brick is. Just a shame the damp people didn't fix the root cause as you previously mentioned in an earlier post.

Once i'm done I really need to know how to deal with the finishing i.e. render the outside, if so with what? I'll also be getting a plasterer in to patch up the area that i'll strip down, but again what should they do internally as i'll need to make sure they can do it?

Or do I need a specialist damp person to come in and have a look, though i suspect we'll be okay once the new gully goes in. Cheers

Ignore the temp gully fix.

IMG_9220.JPEG IMG_9222.JPEG IMG_9223.JPEG IMG_9224.JPEG
 
Internal kitchen Wall now stripped, I went over it with a wire brush drill attachment. I hope that’s enough height wise? There wasn’t any noticeable salt deposits or paint peeling At that height.

The walls appear to be dry which is good news.

A Plasterer is going to check it out, but he mentioned cement with some waterproofing solution silca or something on the phone. I recall ted456 mentioning not to cement it...

Near the pipe work it’s going to be difficult to remove the plaster in that section - will that suffice?
F9944837-E103-4C20-8B56-0C38006989E9.jpeg 23094FBD-482D-412F-AE37-B96C8E8F7F5C.jpeg

Cheers,
Sparky
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top