Hi all,
I put this iflo shower tray, but can't get the middle screw bit through the top of the tray and into the actual trap.
The tray is based onto a 12mm marine and 9mm ply glued and screwed together.
Before fitting tray into place, I cut out the 9mm around the tray to get the middle bit to have more bite into trap.
However, middle bit doesn't reach the trap at all. It's only 12mm it needs to feed through, what am I missing? Or has anyone encountered this before and have any ideas. I've tried a McAlpine trap which was the same.
I put this iflo shower tray, but can't get the middle screw bit through the top of the tray and into the actual trap.
The tray is based onto a 12mm marine and 9mm ply glued and screwed together.
Before fitting tray into place, I cut out the 9mm around the tray to get the middle bit to have more bite into trap.
However, middle bit doesn't reach the trap at all. It's only 12mm it needs to feed through, what am I missing? Or has anyone encountered this before and have any ideas. I've tried a McAlpine trap which was the same.
Attachments
-
IMG_20201001_185219.jpg176.1 KB · Views: 289
-
IMG_20201001_184417.jpg140.6 KB · Views: 284
-
IMG_20201001_184931.jpg144.4 KB · Views: 304
-
IMG_20201001_184520.jpg114.7 KB · Views: 299
-
IMG_20201001_185222.jpg181.6 KB · Views: 281
-
IMG_20201001_184749_1.jpg172.3 KB · Views: 282
-
IMG_20201001_184500.jpg167.9 KB · Views: 303
-
IMG_20201001_185353.jpg216.2 KB · Views: 293