Zannussi dishwasher dead

Is there a thermal fuse on the control board?

thanks
 
Sponsored Links
The one thing that I maybe should have done, with hindsight, was to have measured the resistance between L&N on the plug pins, but , again, without a reference it would be pretty pointless. If I got a resistance value other than infinite, it would indicate that the there was no neutral break on the mains lead - but I have never seen a lead damaged other than on potable appliances as the cable enters that appliance.

No that could also mean there was no break on the live cable in the mains lead and if you got infinite resistance that could mean there is a break in either the lead or SOMEWHERE inside the machine , which you know anyway as you have no power[/QUOTE]


Which is pretty much what I said. And without access to wiring diagrams, knowing that there MAY be a break in the neutral inside the machine is worthless.

On a boiler, one if the checks to prove a fault on a component is to check the wiring harness serving that element, which is what \i thonk you are driving at.[/QUOTE]

No it's not!

Look if you are not going to take our advice and seem to have your mind set on how you want to fix it even though your way is not possible because you don't have access to a wiring diagram then we can't help you.

As for a thermal fuse? No idea , have a look you seem to know what a thermal fuse looks like and whilst you're at it why don't you check for power to that board?
 
I have little experience on dishwashers but if you follow a logical sequence you can eliminate several things even without the info you normally use on a boiler. If you are using a multimeter & measure 230/240v at the lead where it enters the machine ( probably connected to some form of suppressor) check between live & neutral & live & earth. If your input there is ok then check the output from that component. From there the power should go to an on/off switch on the machine facia, make similar checks there. If you have not found the problem by then the only other thing I know about dishwashers is that with a drop down front that has the controls built into it then there will be a harness at the bottom of the door joining the front panel to the machine & with flexing, broken wires in this harness is a common problem.
 
[/QUOTE]

No it's not!

Look if you are not going to take our advice [/QUOTE]





I must have missed the bit where you offered advice, as opposed to a sarcy comment.
 
Sponsored Links

No it's not!

Look if you are not going to take our advice [/QUOTE]





I must have missed the bit where you offered advice, as opposed to a sarcy comment.[/QUOTE]

That wasn't a sarky comment , you have not listened to anybodies advice (including mine)

Two people now (including me) have told you where you need to start, the fact that you are not listening to said advice makes me wonder why you bothered posting

I'm out
 
You clearly cannot read. There was power in the appliance. If you wish nit to help, then fair enough - but why be a dick over it?
 
Did the machine show any signs of warning before it died on you? Did it make any weird noises?

No. It is my daughters, so was not there, but they said it was dead when they went to use it. No issues before hand, although it was never brilliant at its job.

Thanks
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top