Cuitting channels into concrete slab for plumbing and electrics

Joined
22 Jan 2021
Messages
17
Reaction score
0
Country
United Kingdom
We are having to cut out channels in our existing kitchen floor slab for a new kitchen island.

I will need to place an electric feed for the sockets; cold feed, hot feed and a gas pipe. I will also have to re-do some drainage so will dig out for that and re-cover.

So I guess I'm keen on tips/suggestions with regards to

1. depth of channel(s)
2. Plumbing: can I bury pushfit/speedfit type plastic pipes/connectors in concrete for hot/cold - do they need to be lagged/insulated?
3. Gas: The plumber will place that pipe and connect etc. Any advice?
4. Electrics: What type of ducting should I use, if any? It's just one ring main.
5. Screed: What mix/material should I use?
6. DPM - is this required? Not sure if one is there as it's an old extension.
 
Sponsored Links
1. depth of channel(s) - whatever depth you need
2. Plumbing: can I bury pushfit/speedfit type plastic pipes/connectors in concrete for hot/cold - do they need to be lagged/insulated? copper, and lagged
3. Gas: The plumber will place that pipe and connect etc. Any advice? make sure the calcs are done correctly to determine pipe diameter from gas meter, it may require upgrading to 28mm

6. DPM - is this required? Not sure if one is there as it's an old extension. my house was built in early 70's and has dpm, so i imagine it will, whatever you damage you must replace
 
1. depth of channel(s) - whatever depth you need
2. Plumbing: can I bury pushfit/speedfit type plastic pipes/connectors in concrete for hot/cold - do they need to be lagged/insulated? copper, and lagged
3. Gas: The plumber will place that pipe and connect etc. Any advice? make sure the calcs are done correctly to determine pipe diameter from gas meter, it may require upgrading to 28mm

6. DPM - is this required? Not sure if one is there as it's an old extension. my house was built in early 70's and has dpm, so i imagine it will, whatever you damage you must replace

Just out of interest, why Copper and not plastic? In my previous property the builder used plastic.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top