Will soft copper tap tails take compression fittings? Have on to swap where I'd have to alter the pipework unless I can a compression 15mm to 1/2male above it. Thanks
Copper tap tails
- Thread starter XanderHarris
- Start date
Sponsored Links
- Joined
- 27 May 2011
- Messages
- 1,837
- Reaction score
- 786
- Country
Yes. And is better practise than soldering onto them.
I'd be putting in 15mm isolation valves.
Sponsored Links
I have to swap the tap, wonder if I get a new one with short flexis I could cut the pipe above the tee and put a iso valve with a 1/2 male face on the other side. Thanks
You do get them but they aren't the best quality. File the face flat on an ISO valve does the same job or get a set of tap tail adapters.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
