Whirlpool washer only spinning for 3/4 seconds

S

spatchtadley

Joined

10 Sep 2006

Messages

16

Reaction score

0

Country

• 27 Dec 2006

• #1

We have a AWM321 washing machine.

After the last few washes we've done the clothes have been very wet. When I checked the rinse cycle, it fires up for a fast spin, then after about 3 or 5 seconds it stops. The machine then rolls the washing over again for a few seconds before starting another spin for 3/5 seconds.

This continues throughout the rinse cycle.

What would cause this?

 

B

breezer

• 27 Dec 2006

• #2

only a thought, try it empty see what happems

 

S

spatchtadley

Joined

10 Sep 2006

Messages

16

Reaction score

0

Country

• 27 Dec 2006

• #3

Thanks breezer

I left the washing in and ran the gentle spin cycle. This worked OK.

I then removed the washing and ran intensive spin. This worked OK.

I then put the washing back in and ran intensive spin again. This worked OK.

Have you any thoughts on that!!?

 

B

breezer

• 27 Dec 2006

• #4

i dont know your particular m/c but it my be what is called out of balance detection.

basicaly if a wash load is too heavy in one place the m/c when spinning will jump and shake quite violently. i have known a m/c to shake itself to to bits.

I also saw one that headbutted a little child

out of balance detection stops it from doin this.

on a hotpoint, it gets to near spin speed then slows down, stops and goes the other way trying to re distibute the load, if it fails after 3 goes it gives up


on the other hand i may be wrong

 

T

tockworth

Joined

21 Dec 2005

Messages

417

Reaction score

3

Location

Northumberland

Country

• 28 Dec 2006

• #5

"I then put the washing back in and ran intensive spin again. This worked OK. "

What is currently the situation now if you put a normal load in now and run a programme does it not carry out the rinse/spin part of programme or does it not carry out the intensive part of the programme.