Hi,
I use a Champion R484 SP
When im walking behind it the left hand rear wheel drags when on tarmac / concrete etc.
When in use on the grass it seems fine.
Ive taken both rear wheel assemblies of & all the bits som i right back to the plastic back plate.
I have noticed on the side that drags i can see the groove for the circlip to sit it.
See photo.
The drive shaft "red arrow" passes through the metal bracket "green arrow" Then there is a bearing & circuit.There should a visable groove for this circlip to sit in but i dont see it.
Ive removed the backplate so i just have the shaft & the groove is there but doesnt protrude past the bearing enough to apply the circlip.
I think this is my issue as the shaft will then want to ride towards the other side wheel causing this side to then drag.
Do these suffer from say a bent shaft etc ?
I use a Champion R484 SP
When im walking behind it the left hand rear wheel drags when on tarmac / concrete etc.
When in use on the grass it seems fine.
Ive taken both rear wheel assemblies of & all the bits som i right back to the plastic back plate.
I have noticed on the side that drags i can see the groove for the circlip to sit it.
See photo.
The drive shaft "red arrow" passes through the metal bracket "green arrow" Then there is a bearing & circuit.There should a visable groove for this circlip to sit in but i dont see it.
Ive removed the backplate so i just have the shaft & the groove is there but doesnt protrude past the bearing enough to apply the circlip.
I think this is my issue as the shaft will then want to ride towards the other side wheel causing this side to then drag.
Do these suffer from say a bent shaft etc ?