Pyronix Enforcer input type help

steveinoz01 · 22 Oct 2021

Hi

just installed Enforcer V10 for my mum and all good except getting the PIR that is in the entrance hall to do 20 second count down in both exit and entry.

Changed the input type to Entry Route or Final Exit but neither do timed entry and exit?

I have created 3 areas for all set, bedtime and dogs home.

Any help on what I’m getting wrong?

I have set the timers for all areas 20 seconds.

Thanks.

DIYSOS2018 · 22 Oct 2021

What do you have the inputs set as currently and what inputs are in what zones?

What have you set each zones exit mode as?

sparkymarka · 22 Oct 2021

Final exit. Starts entry exit
Entry route let’s you walk passed after the activation of above
Area/Fx ….is entry exit in part set

steveinoz01 · 22 Oct 2021

Thanks for the replies.

I have not ‘set each zones exit mode’ so must have overlooked this! Where in the engineers menu is this?

Will try this when I go back to my mums and see if that is where the issue lies.

Thanks.

sparkymarka · 22 Oct 2021

It’s area set type ….not zone

Bigsosij · 22 Oct 2021

If there is no contact on the entry door then: System options > exit modes > changed to 'timed'. Hall should be programmed as final exit.

steveinoz01 · 8 Nov 2021

Thanks @Bigsosij . I changed the exit mode to timed and the hall to final exit and it now allows timed entry and exit.

Cheers.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

Pyronix Enforcer input type help

Similar threads