Replacing Old Shower

Joined
10 Feb 2005
Messages
639
Reaction score
2
Location
Moray
Country
United Kingdom
I am replacing an old narrow Miralec shower with a new Triton shower, using their Instatrim, which allows pipework to be routed behind the shower. The old appliance is connected using a soldered tap connector which would be difficult to remove due to tiles etc. I want to use a flexi pipe to join to the new shower but need a fitting to connect to the tap connector. Would a 15mm / 1/2" male iron fitting be suitable for this? I assume if I did use this it would still be sealed using a fibre washer rather than PTFE tape on the threads?
 
Sponsored Links
Finding it hard to envisage what you are trying to do :confused:

You may be able to use the male fitting but you should use ptfe on all male threads.

Might look a bit messy though with the flexi :eek:
 
fido said:
I am replacing an old narrow Miralec shower with a new Triton shower, using their Instatrim, which allows pipework to be routed behind the shower. The old appliance is connected using a soldered tap connector which would be difficult to remove due to tiles etc. I want to use a flexi pipe to join to the new shower but need a fitting to connect to the tap connector. Would a 15mm / 1/2" male iron fitting be suitable for this? I assume if I did use this it would still be sealed using a fibre washer rather than PTFE tape on the threads?

wouldnt use a triton



+++++++++++++
Moderator's note:

Delmel, can you use the "reply" button found under the last post, rather than the "quote" button please. This will take up less room and save duplicating everything from the previous post.

Looks like this
reply.gif


Thanks

Mod Rupert
+++++++++++++
 
Sponsored Links
The use of a flexi and choice of Triton were both suggested by the Shower Doctor:
http://showerdoc.co.uk/forum/phpBB2/viewtopic.php?t=810

I bought a male iron fitting today and tried connecting it to an old tap connector but I found that the wall thickness was too great to accomodate the central stub which centralises the fibre washer. I also got the flexi pipe and tried that direct into the tap connector:
flexi1.jpg


The only thing is the end of the threaded section of the flexi is not flat so I will try rubbing it on a sheet of emery layed onto a sheet of glass. I'm not too concerned how the flexi will look as it's hidden inside the Instatrim housing.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top