3/4" Tap Connetor Elbow - Speedfit?

I'm currently fitting a new bathroom suite and have a wall mounted set of bath taps to fit. The wall fittings to the taps have a 3/4" BSP connection and will be mounted on a stud wall.

As there's not much room in the stud cavity, I need to use a 3/4" elbow fitting on the back of the taps. I'm planning on using 15mm Speedfit pipes throughout the installation and wanted to use a JG elbow at the taps - but I can't find one! Does anyone know if JG do a connector for this application?

If not, what is the alternative? I've found this (click here) on Screwfix - can I use it, then reduce it to 15mm to connect up with the Speedfit stuff?

Thanks for your advice.

I'm sure you can look in the SPeedfit catalogue as easily as I can.

Otherwise, what you suggest would be fine.

That's a bit more sarcastic an answer than I was hoping for...

The reason for asking is, I have looked on the Speedfit web site and they don't show such an item... however, it seems some web sites show Speedfit items that aren't on their own home page, making me think their site isn't very comprehensive!