Guys
i have just run approx 80 meters of copper pipe (New extension)
2 bathrooms (both have a separate bath and walk in shower) downstairs WC and utility, so a fair few joints, i have obviously cleaned all the joints of excess Flux and wire wooled them, so they all look bright and new,
bear in mind that this pipe work is not connected to the incoming mains cold water or the central heating boiler at this time,
it suddenly dawned on me that there must be some excess flux on the joint inside the pipe work, if so, what is the best way to clear this,
im assuming that i can poss run some sort of safe cleaner through the pipe work when i pressure test for leaks,
any advice guidance would be appreciated
cheers al
i have just run approx 80 meters of copper pipe (New extension)
2 bathrooms (both have a separate bath and walk in shower) downstairs WC and utility, so a fair few joints, i have obviously cleaned all the joints of excess Flux and wire wooled them, so they all look bright and new,
bear in mind that this pipe work is not connected to the incoming mains cold water or the central heating boiler at this time,
it suddenly dawned on me that there must be some excess flux on the joint inside the pipe work, if so, what is the best way to clear this,
im assuming that i can poss run some sort of safe cleaner through the pipe work when i pressure test for leaks,
any advice guidance would be appreciated
cheers al