What about a botttom exit pan? Or using a swan neck pan connector?
At £180 and 21 days I'd replace.
Please start at the begining and check the inlet filters.
Ah, just the one experiance of them then - Fair enough however myself and many other people refuse to install anything to do with them after...
Either you have been very lucky or had limited experiance of their products. opps meant end of line or cheap imports.:)
Hopefully whoever you go with will steer you away from the company you mentioned ;):whistle:
Any idea what is it like on the fourth floor, have you just moved in by any chance?
So much depends on what you are allowed to do and room
When all else fails reach for the hacksaw. :LOL:
How many floors high is this block of 63 flats of which you complain of low pressure whilst only being on the first floor. Something isn`t...
Thought they retracted when you stopped using them, have to admit I`ve never fitted one myself.
Sorry but none have been installed correctly unless they have their own tank with an air break.
Don`t know your boiler Helen however somebody found their filling loop braided hose and two taps in a kitchen cupboard behind the rice last week.
Correct, and sometimes you just have to be there to see, feel and listen to what is going on (or not happening).
Define being competent in your eyes.
I`m thinking that I could ask one question that would prove your incompetance.
When done can't you unwind and slice off the remaining, that's how I tidy the end
You can back it off a little for those perfect alignment jobs.
They are designed to be serviced and repairable, hope you`re not believing that that one is a few months old. Inlet blocked wouldn`t make it...
Not straight forward to remove the lid, sounds like it needs a good clean out and service from here, might need a part or two and sorry but it`s...
Most pans have a name somewhere, sometimes it is faint and towards the bottom edges.
Separate names with a comma.