Search results

  1. B

    How much support needed for fixing fence posts for arbor on raised/sleeper beds?

    So I recently built a couple of raised sleeper beds with a pathway in between for our garden. They are 2.4m in length and 1.2m in width and 3 sleepers high, meaning 60cm high. I used 50cm 4" x 4" (100mm x 100mm) posts on each inside corner to fix it all together (with 16 150mm screws in each)...
  2. B

    Length of coach screws for floating shelf

    It is just a standard 2x4 CLS16, so just a hair under 50mm thick. Could you explain what you mean here ^ a bit more?
  3. B

    Length of coach screws for floating shelf

    That's encouraging :) I've been too nervous to hang from it myself ...
  4. B

    Length of coach screws for floating shelf

    I used 5mm x 120mm screws. Two of these in rails #1, #3, and #5, and three of these in rails #2 and #4.
  5. B

    Length of coach screws for floating shelf

    I recently made a floating shelf, roughly 2m long. It is a hollow box mounted on a timber bracket with 5 crossbars and attached to 4 studs via 10 x 100mm coach screws with washers. This means that 50mm of the coach screw goes through the 2x4 bracket and then 50mm goes back into the wall. I have...
  6. B

    makita mitre saw table hard to rotate and press plate loose (Makita LS1018LN)

    Thanks! That looks real handy, I'll have to spend some time with that.
  7. B

    makita mitre saw table hard to rotate and press plate loose (Makita LS1018LN)

    Yes :) Interestingly, I've just now found that the saw also seems to get stuck in the up position. I pulled out the stopper pin to raise it but then once it was up, no matter what I do with stopper pin, I can't get it to come back down.
  8. B

    makita mitre saw table hard to rotate and press plate loose (Makita LS1018LN)

    I was able to pick up a Makita LS1018LN for 40 quid the other day since it has a couple problems, but I thought I would try my hand at fixing it to see if I could make it usable again. There are two main problems: 1) When you rotate the table, it does not lock in place in the indents. And it...
  9. B

    Best method for floating bookshelf, 2x4 skeleton or iron-rod brackets

    If I want to make a floating bookshelf around 7-8 feet long (i.e., has to carry a real heavy load), what would be the best method between these two ... 1) 2x4 skeleton and put plywood or plank box over: 2) Buy iron rod brackets...
  10. B

    Building 300cm bookshelf near ceiling, need heavy duty brackets for top of wall shelf

    I am new to this forum and just wanted to get advice regarding the best way to install a bookshelf. I haven't purchased any materials yet, so I am completely open to various methods and different materials. I have a roughly 300cm wall in my home office/guest room. Instead of putting a bookshelf...
Top