Search results

I'm about to fit some reveal trim around the patio doors but there is quite a gap that will be left when the horizontal trim is fitted above the door frame. The gap looks to big to fill with caulk/sealant What's the best options? Thanks

Apologies if this is a question that gets asked lots! I have replaced the kitchen tap with a new one. The braided hoses that come from the tap have the 15mm threaded nut with washer at the end. My hot and cold pipes have a small section of copper pipe with a nut and olive on the end. What...

I'm pretty sure the are inserted into the outlets on the soil stack if that makes sense

They are rubber push fit type. I can remember seeing them when they were fitted

I have a horizontal soil pipe which is boxed in. I have noticed the plasterboard is staining in three locations along the boxing. There are three waste pipes attached to the soil stack in similar locations to where the stains have appeared. Soil pipe was fitted about 5 years ago. From what I...

Hi In our house the soil stack runs horizontally in a boxed in section. The upstairs bathroom waste pipes are connected into this. I have noticed a small water leak patch on the plasterboard of the boxed in section. The soil pipe is is near impossible to access from the void (dormer roof) but I...

Grasped what ‍♂️

You need to get out more. THANKS!

You know the solution. Damaged cable Which I have repaired. I said thanks. what else would you like?

All sorted thanks

it's not exposed as such. It's under decking that is being completed and then internal.

Bugger. Found a scagged cable. It's going to need cutting back and joining. What's the best joint box to use as I can't re-run a new length from panel to bell box unfortunately. Needs to be a weather proof box.

yes. All good once I removed the short

Ah yes. A short between red and black. Will investigate

Panel to bell box... A-A red B-B blue C_C yellow D-D black S-S green I have checked output with meter and im Not getting 12v from the panel.

Texicom 8C

Have just checked for Voltage at the control panel terminals that supply the bell box and no voltage

thanks will look into them

Have just wired up the bellbox as per manual using connections ABCDS like for like at both panel and bell box. system is clear but bell box isn't operating. Have taken cover off and tamper doesn't even come up On the panel the right side led is flashing on the bell box also

it has an egress hinge already fitted but want the window to open beyond 90 degrees