This is some 'Hunter' pipe [if I recall correctly]. Very brittle stuff, I would avoid it at all costs. I have suggested to several customers it...
New one on me today. Heatslave 20/25 locking out. Changed nozzle, checked oil pressure and it ran ok. Left to run for a few mins and then...
CT1 will be your friend here. I temporarily repaired a pin hole in a copper cylinder with it. After replacing the cylinder I couldn't get the CT1...
Use a BRASS tap, 25mm with insert striaght to 15mm or 22mm copper.
Honeywell Valves for me
I use Heldite jointing paste too, as recommended by OFTEC.
Your boiler has a frost stat which fires the burner if the temp inside the boiler casing gets below about 5°C. To stop if firing for long periods,...
Flow switch could be sticking in the 'ON' position
A new filling loop shouldn't take too long to fit and no qualifications needed.
Make sure double check valve end is on the cold water supply end,...
Every Unvented Cylinder I have fitted comes with its own 2 port valve.
I bought the Wolseley Hot Box as a back up to my two torches. It comes with a "Cool Tip"... that remains cold when torch is in use.
Do you have a FROST STAT on your system?
One-piece if two pieces less to lose than three-piece.
I would smear clear silicone sealant around the entire cut surface of the sink cut-out.
Let it dry before putting the sink in otherwise it can get...
Surely your outlet should be connected to a wall-plate elbow that firmly holds the tap in place. Those clips will never hold the tap still.
I would not use speedfit in my own home let alone bury it in a wall.
Would a 25mm to 15mm or 22mm stop tap not be a better bet if you can cut an access panel in the floor?
Leak from the shower head you mean? You either need a new cartridge from triton or you may have a rubber washer that you can replace.
In very Hot weather when thre incoming water temperature is relatively high you may need to use your shower on Medium setting. it could be that on...
Separate names with a comma.