So heres the socket tester, i’ve coloured in the lights as i’ve got a mate having a look at the electrics at the moment.
The middle light was flashing
Yeah i’ve already gone round all the sockets and put the wires back in again.
when you say the 2 sockets do you mean the ones that are working?...
there is a few but they’re under the bathroom tiled floor.
I could remove the cover but dont really know what i’m doing under there.
So on the...
ah right! I get you with that.
i’ve just gone round all sockets this morning, taken them all off and fitted them back on again. Checked for loose...
that makes sense...i’ve just found out 1 socket thats in that circuit works, so surely it would mean that the next socket along is the fault?
I’ve checked and all the neutrals are in the sockets, what about a faulty socket? or could it be that an earth has touched the socket box?
no its a 20A. I’ll check out the sockets and see what i can find. Could it be that a neutral is touch the earth?
I’ve narrowed it down to circuit of sockets on a single breaker, so you reckon take of the face plates and have a look?
No nothing really, today all I’ve done is tape up an old arial wire, filled the hole with expanding foam.
We then plugged the hoover in and...
Today i’ve been filling in a old arial socket thats not used anymore.
I’ve come to use the hoover and all of a sudden some of the plug...
Yeah i did think that as my next option, i just thought if i could buy it ready done its easier isn't it
I'll see what i can find cheers
yeah i was thinking of cutting back a larger section and putting a wider board in, god knows wheres these tiny boards came from
I’ve recently plumbed in a new rad upstairs and damaged a few floorboards getting to the pipes.
I need to replace them but i’ve measured and...
♂️♂️ Thats annoying, i should’ve researched it as i’ve fitted a 32mm pipe
back to the drawing board, i’ve just found a waste trap that includes...
could you suggest a standpipe and trap to get? This is the only one i could find that fit onto a 32mm Sweld pipe
I’ve measured the internal diameter of that standpipe so i know its 28mm i’m just unsure whether i’d need a solvent weld pipe or a pushfit as the...
i couldnt really put the hole lower through the wall as there wouldnt be much of a drop outside.
thats the standpipe that came with the trap, i...
Cheers Terry, i’ve put a photo on, i understand the drop has to be a minimum of 65cm
Separate names with a comma.