Says polypipe on the pipe so, polypipe coupling of the size you need... 10 or 15mm!
He'll just need to learn the parameters.
I think you mean 2port valves, not diverter.
What models are they?
New synchron or new actuator.
Sorry @Madrab only just seen your reply.
Needless to say, I ripped the whole lot out as the leak had been going on for years and the joists were...
Pun intended? :whistle:
I'd think about changing the "friend" who gave you the seat!
Or did you fish it out of a skip?
I use them and it's a matter of correct usage. They work well for me and I met the guy that invented them at a tool show.
MI's are manufacturers instructions.
They will tell you the minimum flow rate required and then you just use a measuring jug over a set time to...
Ditra is good enough for the tiles I suppose, but like you, not done it or seen it done before! Perhaps post in the tiling forum, here or on the...
You can try pipe cutter or wire strippers.
Maybe try heating it as well. Just got to adapt and overcome really, same as getting oil paint off...
More likely to be flow rate.
Check MI's then test flow rate from outlet in flat 1 to see if it meets requirements of shower unit.
EV needs to be open to atmosphere to be properly recharged.
Ideally you want to cut out and replace the section of 4" that has the 2 strap on bosses on it then start again with a coupling, a slip coupling...
Check to see if the 2 plastic push/flush rods have been snapped short to the correct length. Often they are not and can be too long, so that they...
Try some penetrating oil and maybe a hot hairdryer on it for 10mins.
Sometimes they come out in bits... Plastic ones usually, so you should be OK...
Who fixed it?
Separate names with a comma.