I can't remember how long I left it to cure, probably a day, it was painted 4 months ago approx. I also wonder if the undercoat being old may...
Hi All, I recently refurbished our bathroom, the skirting board and door were lightly rubbed down, I then applied some old oil based undercoat...
Cheers Rob, I will check the drain is on the return pipe. Most helpful once again. Victor
Rob, Thanks for info. The way in doing it using the drain cock as the exit for water can you see any problems or should I use pipe where I'm...
I was going to use the drain dock next to one of the radiators but could use open exit as you say. I think I saw the 2bar figure on this forum...
as I'm fitting omega filter with valves on return pipe, I will just turn those valves off so water cannot flow via return to boiler. I am sure...
I am fitting a new radiator and central heating magnetic filter fernox omega tf1 and was going to do a mains water flush of the system. My...
I am installing small square glass mosaic tile sheets. I have stuck the plastic backer sheet on them but was still having difficulties...
Thanks all, I will fit the 60mm trap.
Ah I thought I read somewhere that 75mm was the min depth for bath seal if its not going to hopper or gulley. Thanks for that info.
I was thinking of fitting a low extended mcalpine trap sm10e which has a 60mm seal to my bath, my question is are these traps only meant to be...
The trap was from toolstation. I replaced the o-rings which came with the trap for some thin flat rubber washers from another trap and it now...
Also waste comes out of bath at an angle due to bath manufacture.
I think these o-rings are not sealing very well compared to the flat washers you can get with fittings
Silicone in bath waste which has sealed it. Now having problems getting the trap to seal, its one I bought from toolstation and has an oring at...
Large washer underneath, its an ideal standard waste on an ideal standard bath.
Trying to get bath waste to seal but having problems, have tried washers only, tried adding plumbers mait but still leaking. Don't know if I put...
Thanks madrab, baths in and silconed down. Has been good experience for my son who is about to do his year two plumbing.
What's best way to level up bath, frame is built and ready to have thick layer of silicone on. I want the bath to squish the silicone to fill up...
Quick question, would you use sanitary sealant to glue bath to frame and wall or general purpose.
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice