I have met this combination before. It was a pair of appliances (oven and hob) designed to be connected together internally (by way of a special...
Could it not be incorporated into the DB? Then run a new feed from there to the fan or light or whatever this thread was about now!! Otherwise, a...
I have experienced the fluorescent lamps designed to replace tungsten halogen - they appear to be fine when left on for longish periods but do not...
I'm sure that is correct - all line conductors must disconnect at the same time (on a 3 phase supply) - that is why although a motor could be...
Unfortunately it is difficult to satisfy all of the factors you describe. Assuming you still want to replace the floodlights then there are a few...
Presumably the timer is so that the fan will stay running for a pre-determined length of time after you have switched the light off. If this is...
Thank you for the replies. I too have had a busy week and only just managed to get back on here. I have priced a 254x146x31kg and I will most...
I realise that may have sounded a little strange! It is a "standard" garage (if there is such a thing!) of 7.7m x 4.1m with walls of 3m high to...
Thanks again for the reply. I take on board what you say about the full length of 7.4m. If this was reduced to 5.4m then the difference in size...
Thanks for the reply - very helpful! Just to clarify as I'm not by any means an expert in this field(!), a catnic would suffice for the roller...
Thanks for the replies. Although "messy" as you say, a column in the centre of two widthways beams would be ok. I would like thelift at the front...
You're right - I expect it will be silly money!! The width is 4.1m to outer skins. I was thinkiing about using the width for the lifting gear...
I used to connect my 110v tranny to a 110v supply using a lead with two 110v plugs on it. Then I plugged the 240v plug into a double socket and...
Hi. I am a newbie to this forum so please forgive my questions if they appear basic! I am in the process of building a garage using 4 inch solid...
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice