Yes the model I have doesn't come with EOL resisters included and I think you forgot to attach something ? thanks.
Hi Everyone, I've previously setup an alarm system with honeywell 8ir103 PIRs with the resisters etc. I'm installing another G2 system and the...
Thanks, i just wasn't sure with it being low voltage and very thin cable that it should be ran the same route as all the twin and earth grey cables.
I want to install a 12v dc smart doorbell and run the cabling under floorboards along the joist cable clipped, along with all the twin and earth...
Ta! I'm guessing for normal domestic install a power rio wouldn't be necessary although if say have a 50 zone flex with say 10 pirs this would...
Thanks I thought that might be the case. I just think logically that if the keypad is connected to a rio and the rio fails the whole system will...
Is that the only supported configurations a single daisy chain or panel being in the middle. How many lines out can I run from the panel. Just not...
I have a galaxy panel which currently has a keypad linked straight to the panel in the loft using all on board zones and an RF portal next to the...
it's this model Hikvision Video Doorbell WiFi model DS-KB6403-WIP
Thanks all. So what alternative could I use without using the cheap and high failure rate of standard plugin 12v dc transformers that you can get...
defo not a cable issue as when it didn't work I connected a 10cm cable from the transformer directly to the doorbell! hence why then went back to...
could well be the problem with mis printed specification info from the manufacturer!
It's a hikvision WiFi doorbell.
Spec says 12v dc and when you look on the BG transformer spec sheet, it says 12v dc?...
Nope, it's an IP video doorbell
OK - so with the meter set to 200V AC i get the following readings : across 0v and 12v - Meter Read 16V AC across 0v and 24v - Meter read 28.8V AC...
well i only resorted to testing with a multimeter because I installed the first 2 I had straight off and the doorbell wouldn't power up! I have...
[ATTACH] [ATTACH]
Yes I've set the meter to 200v ac and 20v dc and can't get a steady output reading on either just returns 0. jumps to some random numbers when...
Hi. I purchased 2 x BG Doorbell Transformers both of which I am unable to get any DC output out of any of the terminals. I took them back for...
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice