Your picture looks more Tudor or Elizabethan than Victorian to me. Perhaps you will need to sort out which era you want first! :?
Any of the above will work, depends what you want the final finish to look like and how much disruption you are prepared for. But, I know...
Use some common sense. Complete the transaction on the 1st of the month - seller gets tax back for the preceding complete month, buyer taxes car -...
That part of the process has never been any different. Refunds were only ever for full months and if you want to use an untaxed car on the road...
Plus you can use the cheaper tablets (if there's a deal going) and not have to worry if they are multi-functional tablets.
Mira have a full range of spares on their web site http://www.mirashowers.co.uk/home.htm If I was you, I'd just replace the whole cartridge. 5...
You need one of these: http://www.screwfix.com/p/washing-machine-y-piece-bsp/81000 The machine will work quite happily on cold only. In fact...
For cutting in wall to ceiling I use a 2" brush as it is easier to strike a good solid line rather than using a small brush. Cutting in brushes...
Personally I always use salt regardless of the type of tablet I use. I prefer to rely on the function of the salt in the machine to do the...
Have you tried holding the On/Off button in for a number of seconds, maybe up to 10? On a lot of appliances that will reset the machine and cancel...
I tiled my kitchen with some very similar irregular tiles, much the same as yours. I used spacers horizontally and vertically to achieve fairly...
Setting the programmes is easy and just a matter of following the prompts in the display. If in any doubt, ask a 5yr old :D
Ok, so open this rad's lockshield fully, let it get hot, then open the others gradually so you get a balanced flow to all. Not the most...
Just repeating what all the manufacturers put in their instructions - and here's the thing - even the gas cookers. Go figure that! :?
No washer needed. Just wrap with PTFE so it is a tight fit by hand, then tighten with spanner/grips until it feels firm. If it goes right in...
Far easier to just remove the trap/U bend and clean it out. Just remember to put a bucket underneath before you undo it.
Give it another 3 yrs without the foil lining and we'll find out for sure :)
Are both of them dripping? Can you tell if it is from the 3/4" coupling or the 15mm compression end? I would: remove both, rewrap the 3/4" end...
In a word - yes! Reflecting the heat back up to the element. If you look in all the manufacturers' instructions they explicitly state NOT to...
Do you line the grill pan with foil by any chance?
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice