On my sink basin, ive correctly assembled the pop up rods with the basin, when i push down on the rod behind the taps the waste plug pops up as...
ive just quoted a rear at £1200 materials and labour - specialist coloured render
how many sq metres?
whats on the bricks? i always give a good fungicidal wash scrubbing with a wire brush, try that
if there's no holes in the plaster board, just tile over it make sure you use plenty of pva before you tile though
best thing to do is work for a company while you set yourself up,. your gaining experience you dont have picking up tricks of the trade going...
cheers scotsman for the advice, ive taken it to a repair centre thanks anyway
dot and dab much quicker and easier, 9.5 is fine
thanks for the advice , drained all the water out again hopefully it'll be ok , water comes in when i turn the machine on now. the lower arm...
im a plasterer, mainly doing rendering & dashing, where are u based? 4 - 1 ratio with a good measue of feb mix
pushed the machine back bit of water came out of a hole below where the water supply hose is. carried out 2 cycles no problem tried a 3rd and the...
yeah a couple of scratch coats will level out, regarding mesh depends on what render your using. I use it every time with basecoat
has it been skimmed yet? is the board damp?
machine wasnt tipped on its side , there is a bit of water when you pull the filter out in the base - is this a blockage? does a blockage prevent...
no, took the hose off then turned the water supply back on and water came through fine - for some reason its not going into the machine
tap is turned on properly and there is no kink in the hose, its fitted exactly as it was before
never do work with a company that has approached you, just paint over it all - you can fill the cracks in by mixing a bit of water with cement...
hi, i disconnected my dishwasher to tile my kitchen floor, after re connecting the dishwasher. i tried a cycle and no water enters the dishwasher,...
if your pebbledash is loose, coming off (test with a lump hammer if it feels loose) best off hacking it off . If solid,go over it, a basecoat...
Separate names with a comma.
Visiting from the US? Why not try DIYnot.US instead? Click here to continue to DIYnot.US.Dismiss Notice