Thanks, always useful stuff for cleaning!
Thanks, think i'm settled on that for a primer.
How about tough top coats. Its solvent much stronger than water based? Two pack? 2k? Enamel? Or...
I am creating a old fashioned semaphore signal arm for a railway. Its made of Red western Cedar wood.
The plan is to prime and paint it...
Thank you @JobAndKnock you are always very helpful on here!
Thanks, I have one of these, so sounds like it will do the job....
Actually I have seen a metal plate on the rear of some signal arms. As you can see on one end, the 'pivot' end is encased with the metal bracket,...
Hi and thanks.
I do have a table saw yes.
Also, I wasnt able to source any 250mm wide cedar. Max seems to be 200-220mm from about 15 places I...
I am recreating an old railway signal arm to replace a rotten one.
Due to the size:
Length 1700mm, width 250mm, thickness 18/19mm, I...
Thanks. Can the gate post be demolished in sections say a few brick layers, and rebuilt with those sections, or will it have to be take apart and...
Im going to be widening the driveway, and also making the brickwall and pier shorter for wider vehicle access.
Probably going to shorten...
Ok, Thanks. I will cap of the rad pipes and refill the system.
Looking to drain the heating system on my Worcester Bosch combi boiler to do some radiator work.
The work might take a couple of weeks...
Thanks for the input guys!
Would probably be better yes, but people would complain its not heritage, trust me, they would know somehow.:LOL:
Something a little different here.
I have been tasked to recreate a railway semaphore signal arm.
Size approx 1400mm, 249mm, 20mm.
Thanks. does 1/2inch refer to the internal diameter of the pipe?
Just want to check the size of blank I need for the radiator pipe.
Is 3/4" correct for this?
Caliper display shown in inches in photo....
Ah, so that powers the PIR?
So I have a light in the porch, which is controlled by a switch in the hallway indoors.
I want to put a PIR in the porch so the light...
Separate names with a comma.