Check battery leads are connected correctly.
Not uncommon that new battery is totally flat and control panel will not charge battery.
Do you have 12 volts on battery leads without battery connected ?
What's the current draw of your system.
Take reading in standby and then in alarm. Bell circuit max 1amp.
Why is the bell tamper linked out in...
Large CQR surface contact[ATTACH]
Orisec also sell ONLY to registered companies as well.
Years ago Galaxy alarm control panels were only available to registered installers , now...
Your system may be programmed to engineer reset on tamper .
When opening a tampered device the system may require the engineer code to reset the...
Caution when defaulting control panels.
This could lead to a full reprogramming of system. If reprogramming is beyond your diy skills then could...
What zone numbers are lit on keypad following activation?
Does this happen when any device is triggered?
Sound like long entry delay timer.
Latest psu version HAD1000-5
Texecom also recommend up grading firmware to version5.04
These psu's are a pain in the a***. Texecom need to be...
Take photo of control panel and keypad if unsure of make and model
What model, accents,galaxy etc.
Most domestic may not require engineer code to reset a tamper.
Texecom and Pyronix.
Pyronix for cctv integration with alarm.
Texecom 8c is basic alarm control panel with LED zone indication.
Other control panels are available with LCD zone description
Depends on your...
Great control panel in it's day. Only problem was you needed engineer to change customer code.
No spare available any more,time to replace I think.
If no 230v power,then remove control panel off wall.
Are there any led's lit on control panel ?
What do you mean by cut? Disconnected from control panel or cable cut with cutters ?
If there is no...
Sound like Texecom have got it wrong again.
Us installers will yet again take the flack for Texecom's incompetence at our cost and not theirs.
Look at other threads and posts in this forum. Loads to do with yale and bleeping problems.
Suggest you start a new thread.
Post photo of pcb with links fitted.
Could be other tamper issue but need to see PCB, bell tamper, rkp tamper etc.
Separate names with a comma.