It's an Andrew James Halogen Oven. Specifically, the bulb component. 1200/1400 watt.
Yes! Thank you! :D
Thanks both for the advice.
Perhaps I can get by with one of these: www.molex.com/molex/products/part-detail/crimp_terminals/0304902002
I've attached a pic of a male plug connector I require. The male comes off a Halogen Oven bulb (which I need to replace) and it slots into...
I have an issue with moisture build-up in the workshop so would it be a bad idea to put the wife's tumble dryer in there even though it is a...
Thanks for the link; very handy
My shed has been rendered but not painted, so I'm still getting damp patches on the interior walls. What's the best waterproof exterior...
May as well stick to some screws then.
Thank you Woody.
I've been doing a bit of research and apparently it's safer to use nails for timber framing due to their tensile strength. If I remember correctly...
I know it makes sense but it's still mad to read that.
So I assume the more expensive models are those that throw out the higher end KWh of heat.
I like your sig (Farage) by the way.
Sounds just like my workshop.
I'm wary of oil rads since the last one I had was pretty ineffective at £60. Von Haus too, which are apparently a good make. Specifically this...
A few have recommended the same thing. Perhaps I'll take a look.
Halogen heaters look pretty good too.
Thank you very much for all the help!
Looks like this will do nicely:...
Rockwool is definitely a possibility. Isn't it, a health hazard though? I was googling it and it's like, yes no yes no perhaps maybe.
Would I still not need a vapour barrier with Rockwool?
Also, you say go for Rockwool, is that because insulation panels (like Kingspan) are solid...
Ok thanks for the advice
Sure, that will go over the unpainted render, I thought I'd benefit from painting something on the interior wall as well.
Separate names with a comma.