Any ideal if a Dudley turbo adjustable syphon would fit this toilet. Or do I really need one with exactly the same dimensions?
Is it possible to scribe a kitchen work top from 10mm to nothing as the wall runs out on one side were the work top touches the side wall ?
If fitting a shower tray on legs. Up to plasterboarded walls. One dot and dab, the other a stud wall. Would you usually fit the tray flush to the...
Will soft copper tap tails take compression fittings? Have on to swap where I'd have to alter the pipework unless I can a compression 15mm to...
What's the best way of fixing to this just pilot drill and screw? Thanks.
Is there a way of tightening the tap in to this without screwing the union to the wall first. There's no where on the hose union backplate to hold...
Does it need to be above a required temperature for solvent weld glue to be effective? Thanks
What width is the listed size of a basin the back width or the wide at it largest point.
Like the basin in the picture, thanks.
Do 40mm pipe snugs fit around pushfit fittings?
Is the maximum horizontal clipping distance for this 0.5meter?
Do they still sell these is a boss adapter solvent to pushfit I think. Thanks.
I have fit a redring electric shower it's yet to be wired up. But upon turning the water on to check for leaks water started flowing though the...
Does every house need an external soil vent or in some cases will a air admittance valve be OK? Each house just has one stack, for one bathroom.
How do this plumb in? Drill through the unit to the waste/cold connections below?
I have fit these before and they have come with 1/2inch male threads for a flexi to connect on to will this accept a compression fitting. Need to...
When a tap is listed as having a smooth body. Does this mean it's not got a pop up waste lever at the back?
Are these any good for cutting a cast pipe and converting to plastic? Or is not all cast 110mm diameter? That's the photo
Does that gray plastic clip just pull off? Allowing the fill valve to be removed?
If you cut a olive off a pipe. Is it usually OK to solder on to where it has been cut off or will the indentation made it hard to solder correctly?
How tight should the female end of a tap connector with a rubber washer in be tightened on a 1/2 male fitting or a iso valve with 1/2inch at one...
Separate names with a comma.