Floor or roof xtratherm has the same R (thermal resistance) value but different products can have different values
And if you turn your lockshields off upstairs and TRVs on highest setting downstairs what happens
A) or gravel board
Yes. with all the minimum stresses they allow for in the steel, an allowance for someone driving at speed over it giving static and dynamic forces...
A photo about 10ft further back would have been more beneficial, fortunately Woody can see the wider picture;-)
I would change the orientation of the wood you place across the rafters so they are vertical and screw/glue together. Place a spreader plate piece...
Bump after 5 minutes? If thats urgent yes its a brilliant proposal do as you suggest - or wait for some more considered responses
You are allowed to switch the heating on now so you don't have to wait till the evening to report back
Which gives the same value as you, only difference I have to calculate it (or my spreadsheet does) and you memorise these values, awesome ;-)
As an aside have you checked what speed setting the pump is set at 1,2 or 3. If its not 3 turn it up a notch. And as suggested turn off the other...
Similar thing Tony except my understanding is that the basic stresses are applicable to a 300 deep beam and there is a K7 factor - (300/h)0.11 -...
My bending stress in BS5268 shows 5.3N/mm which factors up to 6.1 with load sharing?
Meant 72 x 145
If they are actually sized 75 x 150 (c24) they will span 4.1m if your floor finish is restricted to 0.25kn/m2 (22mm chipboard = 0.15kN/m2)....
Albert Pierrepoint never had a problem, as he said, his victims had been tried and found guilty and he just carried out what was required by the law
OK £64000 question, I have an Ideal FF250 25 years old, only issue has been extractor fan/bearings required sorting a few times but ready to...
There is block paving sealer which may be be suitable
Unfortunately the man who raped and killed 2 little girls in the 80s is now running free, I'd prefer him dead.
Separate names with a comma.