I am sorry I placed this yesterday wrongly in building.
Would any roofers have a look, thank you.
The notice in loft was placed there by insulation installers.
I have been up on my ladder and looked as closely as I can and the tiles all seem good and in position.
Could it be that as suggested it is simply...
I live in a semi bungalow late 60s build.
Water is dripping down rear small bedroom light fitting, which I have made safe.
I cannot see any roof...
Thanks for your reply's, what I am unsure about was the possible movement of the timber due to temperature changes etc of the timber.
I am not...
I hope this question is in the correct section.
I am going to run a 1.5mm 3 core flex from my garage to a timber shed in 20mm plastic conduit...
I have removed my old 6ft x 8ft shed of around 25yrs old erected by the house previous owner.
It was up-against the rear of my garage on one side...
Have now cracked it, it was pointed out to me by a Texecom Tech expert to check the area address setting of the keypad.
Doing this I discovered...
Thank you again sparkymarka for your kind responce.
I have doubled checked the settings with the manual all the sounder options are on as in the...
To the expander spk o/p
Thanks for replay.
I have checked and area B spk is enabled, I have also realised there are no tones also from panel buzzer etc.
I have no exit tones from the indoor speaker when setting area b
And how do I change text for part set in area a
I have changed the full unset...
Sorry I am a little confused do you mean log into the app on my smartphone ?
Or log into the panel
I have looked in the app but cannot seem to...
Sorry for my delay in getting back
Just to go back to the beginning when I log into to the app. with either the master or the area A code the...
I believe so
When I am logging in to the app.I use the master code.
Yes using separate codes
As regards all area setting I will need to check when I return to home
I have a Smartcom fitted to my Premier Elite 24.
It fails to report anything in area B.
However with area A it reports every action/event
Its a two area set up, when area B is armed and then area A is armed in part set ( bedtime )
The kp display toggles ever one second from area A...
Thanks for info, I assume if I replace O ring or vent plug with both valves off water escape should be minimal with no loss of system pressure.
Separate names with a comma.