Is this the push/pull tool to consider for a wishbone ball joint?
This is the ball joint. The seller stocks both Blueprint and Febi, brands owned by Bilstein.
Had the ball joint been on a VW Bora, it would...
The bushes are still good so I've ordered a ball joint to fit.
Blueprint manufactures both the whole wishbone and the ball joint so I have my options.
Thanks for the feedback.
The local factors seem to stock Napa and Apec of which I've used both. So long as you get a good brake pedal, that's the...
Who are currently the better makers of wishbone arms?
Hyundai i20 1.4 2009 PB model.
I believe the ball itself is splined in and circlip locked but I don't know how tight its in the arm.
Noted, thanks All!
Are the ball joints easily tapped out/in or is a whole new arm easier?
I got a Mintex fixing kit, slider pin boots, pad shims and pin grease, to fit the pads with because Mintex are the only kit available. Boots are...
What does the mot allow regarding slight play which you can feel with a shake of the wheel?
All the factors in my area seem focussed on Apec and Napa.
simplycarparts, who trade on ebay, stock both BluePrint and Febi.
The BP discs and...
Had our Hyundai i20 in for test and vent ribs on the discs are rotting a bit.
Was favouring Mintex pads and discs but have made the discovery,...
The schaeffler.com website for LUK clutch kits.
Just a suggestion! Research which clutch brand is supplied and installed at the Seat factories.
It built into a cupboard in the kitchen and fridge stat is set to 1.
The door's rubber seal seems good and has magnetic close.
The ice build up...
Indeed, the local breakers had a one. Simply pulled the clip off, all sorted. Same slave even though it was a petrol and ours is a TDI.
This is the slave and I'm trying to source the pipe clip.
Have tried the local VW but the clip is only available with the slave. The slave on the...
The local tyre centre's impact gun should loosen it.
If you want a breaker bar for strong arm jobs, I recommend this one. And personally, I only...
Mine is the Bosch 1400 XPress.
The arms on the support bracket/bearing shaft, known as the spider, on the rear of the drum, were corroded and...
I've traced the reason the water is not pumping. The wire between the pump's switch and the pump being open circuit, so broken.
One end of the...
Separate names with a comma.