They should have a Photo ID Card with details of G3 Course and Expiry date
This is some 'Hunter' pipe [if I recall correctly]. Very brittle stuff, I would avoid it at all costs. I have suggested to several customers it...
New one on me today. Heatslave 20/25 locking out. Changed nozzle, checked oil pressure and it ran ok. Left to run for a few mins and then...
CT1 will be your friend here. I temporarily repaired a pin hole in a copper cylinder with it. After replacing the cylinder I couldn't get the CT1...
Use a BRASS tap, 25mm with insert striaght to 15mm or 22mm copper.
Honeywell Valves for me
I use Heldite jointing paste too, as recommended by OFTEC.
Your boiler has a frost stat which fires the burner if the temp inside the boiler casing gets below about 5°C. To stop if firing for long periods,...
Flow switch could be sticking in the 'ON' position
A new filling loop shouldn't take too long to fit and no qualifications needed.
Make sure double check valve end is on the cold water supply end,...
Every Unvented Cylinder I have fitted comes with its own 2 port valve.
I bought the Wolseley Hot Box as a back up to my two torches. It comes with a "Cool Tip"... that remains cold when torch is in use.
Do you have a FROST STAT on your system?
One-piece if two pieces less to lose than three-piece.
I would smear clear silicone sealant around the entire cut surface of the sink cut-out.
Let it dry before putting the sink in otherwise it can get...
Surely your outlet should be connected to a wall-plate elbow that firmly holds the tap in place. Those clips will never hold the tap still.
I would not use speedfit in my own home let alone bury it in a wall.
Would a 25mm to 15mm or 22mm stop tap not be a better bet if you can cut an access panel in the floor?
Leak from the shower head you mean? You either need a new cartridge from triton or you may have a rubber washer that you can replace.
Separate names with a comma.