I have a tap to change on this so will have a new pop up waste bar. Is it possible just to just replace the washer and and little metal threaded...
Is swapping the cartridges in these similar to a normal tap cartridge?
Well it did seem to nip up 1/8 of a turn or so and isn't leaking now. Worth leaving alone? Is bottom of the system so a full drain down to paste etc.
Thanks must be a slow very small leak. Would paste be an option too?
What would be the best way of fixing this leak it doesn't drip just builds up like that after a day of the water being on. Thanks. Guessing it's...
Thanks it didn't seem as thick as the heat resistant stuff they sell now or the stuff I have seen. Thanks again!
Is this 0.75mm flex heat resistant? I don't think it is. Thanks
Should it bite up to the pipe on it ok.
Is it possible to swap the p trap on a double bowl connector for a anti vac one?
Can these go into the top of a waterless traps inline adapter or are the rubber push fit 32mm to 22mm reducers better.
Looked online some blubber taps you can adjust the flow on the tap. not sure if you can on the one I fit was no instructions. the ones online it...
The service valve turned down abit do a similar job?
Do you know roughly how much these cost? Wasn't aware these needed fitting?
So either fit one of them or turn the iso right down then?
Iso valve, have to it on nearly off to stop it didn't really make much difference.
Thanks all I noticed with it is if you pressed the button down fully, it over sprayed over the fountains catchment area.
It wouldn't no. Its just that as agile say spit etc could fall on the tap with it having an upward facing spout.
Thanks its and upward facing jet, so will fit a double check valve. Also does anyone know what kind of height to set at. Would the normal basin...
As the title don't really need 25meters
Thanks not seen it yet off to look tomorrow. Agile your description of when one may and may not need one makes sense.
Separate names with a comma.