Via a keypad or fob?
The bell box tamper may fail for a fraction of a second which is enough to trigger the tamper fault on the panel.
See, I told you:)
I seem to remember these panels were rascal made by Guardall if that's any use.
Of course I could be wrong (I've been wrong before according to...
Remove the power, remove the battery.
The bell/ siren may or may not sound but if it does it will either time out or run until the battery goes flat.
Are you sure it's the alarm that's beeping?
It should hold everything in the nvm so no need for any reprogramming.
The link works for me by the way.
If so power it down, move bell box, power it back up.
Pull down white fuse holder.
Put in new fuse.
Push fuse holder back in.
No, just program them as unused
i stand corrected :oops:
since when did the word OMIT look like a squinting eye?
i would not advise using a 7 amp hour with that panel, the charging circuit is not man enough to handle it!!!
why not its's the same board...
have a look here
your right in your observation i work for n.g and their apprentices are nothing more than glorified labourers .i did three years on one...
if thats a guartec 300 i'll eat it :D
oh yeah, forgot about that bit :oops:
i seem to remember something about putting a link between set pos and pa and then powering up on accenta systems to default .don't know if it...
dont series the power :shock:
Separate names with a comma.